Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

如何配置Dell Networking Force10交换机上的端口监控/镜像

This article may have been automatically translated. If you have any feedback regarding its quality, please let us know using the form at the bottom of this page.

Article Content


Instructions

 

本文介绍如何在Dell Networking Force10交换机上设置并验证端口监控(镜像)。

 

 


 

重要须知

 

  • 物理和逻辑接口(如虚拟局域网[VLAN]和端口通道)上均支持端口监控。
  • 受监控的(来源)和监控端口(目标)必须在同一交换机上。
  • 通常,监控端口应将无IP地址和无关机作为唯一配置。  监控端口也可能不是VLAN的成员。
  • 监控会话中可能只有一个目标端口。
  • 一个端口监控会话可有多个来源语句。
  • 一个目标端口可在多个会话中使用。

 

配置端口监控程序会话

 

命令

用途

Force10# configure

进入配置模式。

Force10(conf)# interface te 0/2

输入用于监控程序会话的目标端口。  确认它没有配置。 


Force10(conf-if-te-0/2)# no switchport
 
删除可能配置的任何第2层。

Force10(conf-if-te-0/2)# no ip address

删除可能配置的任何IP地址。

Force10(conf-if-te-0/2)# no shutdown

启用此端口。

Force10(conf-if-te-0/2)#exit

保留目标端口接口。

Force10(conf)# monitor session 0

设置并识别会话编号。范围0 - 65535。

Force10(conf-mon-sess-0)#source te 0/1 destination te 0/2 direction both

设置来源(您要监控的端口)。  设置目标(您发送受监控数据包的端口)。  设置方向(二者/Rx/Tx)。

 

 

验证端口监控程序会话

 

Force10#show monitor session 0
 
  会话ID  来源      目标      目录    模式    源IP   目标IP
  ------      ------         -----------        ---     ----       ---------      --------
   0      层0/1        层0/2        二者    端口       不适用        不适用   

 

 

Article Properties


Affected Product

Force10 S60-44T

Last Published Date

21 Feb 2021

Version

3

Article Type

How To