GDDR : La mise à niveau vers z/OS 2.5 entraîne l’exécution d’abends et des SYSTÈMES de contrôle GDDR en mode dégradé
Summary: La mise à niveau vers z/OS 2.5 entraîne des baisses dans Geographically Dispersed Disaster Restart (GDDR) et GDDR Control SYSTEMS (C-SYS) s’exécute en mode dégradé.
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Symptoms
Le logiciel d’exploitation mainframe est mis à jour vers le niveau logiciel z/OS 2.5 avec une tolérance de maintenance. z/OS 2.5 est utilisé pour un nouveau processeur IBM z16.
GDDR GDDRMAIN a démarré avec plusieurs ABEND après l’application de la maintenance z/OS :
- HBM signale l’erreur ci-dessous au démarrage de GDDRMAIN, l’hôte GDDR est en mode dégradé :
ABEND S0E0-29
- GDDRRPT signale l’erreur ci-dessous lors de l’arrêt GDDRMAIN :
ABEND S0E0-28
Le message d’erreur suivant s’affiche dans les sorties du moniteur d’événements GDDR (EVM) et du moniteur de pulsations (HBM) :
GDDUG86E No matching GDDR systems found
Si la demande ABEND S0E0-28 se produit lors de l’arrêt de GDDRMAIN, puis un Abend S067-04 peut se produire si GDDRMAIN est remis en place.
Cause
Une
De plus, un
ABEND S0E0-29 peut se produire lors du démarrage de GDDRMAIN dans la sous-tâche HBM au niveau du module GDDREVMI, décalage 0005AF74.
PSW 183158F0 0010D507 3000F154Cela entraîne l’arrêt de la sous-tâche HBM et laisse GDDRMAIN sans capacités de surveillance des pulsations. L’hôte GDDR s’exécute en mode dégradé. GDDREVMI est mis à jour pour effacer REGISTER AR15 avant d’utiliser le registre afin d’éviter un
ABEND S0E0-29.
De plus, un
ABEND S0E0-28 peut se produire dans GDDRRPT lors de l’arrêt de GDDRMAIN à GDDRMAIN, décalage 0006EAB2.
PSW D24FD37A 1000D207 D37D5004GDDRRPT est mis à jour pour effacer REGISTER AR1 afin d’éviter un
ABEND S0E0-28. GDDRMAIN est mis à jour pour vérifier que le jeton ALET (Access List Entry Token) de l’espace de données 2 est valide. Cette action est effectuée avant d’accéder à l’espace de données d’une autre instance GDDR. Cette action permet d’éviter un Abend S067-04 dans le démarrage GDDRMAIN en raison d’une autre instance GDDR qui ne s’arrête pas correctement.Resolution
Solution de contournement :
- Aucun pour ABEND S0E0-29, mais les hôtes GDDR continuent de s’exécuter en mode dégradé.
- Un chargement initial de programme (IPL) de la partition logique (LPAR) est nécessaire pour effacer la mémoire si un
Abend S067-04Survient.
Correctif permanent :
- Pour GDDR 6.0, les GD60004 et GD60005 PTF (Program Temporary Fix) peuvent être téléchargés à partir du support Dell.
- Pour GDDR 6.1, le problème est résolu dans le produit de base. Il est disponible au téléchargement à partir du site de support Dell.
Additional Information
Description du correctif temporaire de programme (PTF) :
++PTF(GD60004) REWORK(2022315) .
++VER(Z038) FMID(GDDR600)
/*
*-------------------------------------------------------------
* PROBLEM DESCRIPTION(S):
* ------------------------------------------------------------
*
* PROBLEM FIXED: GDDR-3459
* USERS AFFECTED: GDDR users
* PROBLEM DESCRIPTION: Warning message GDDUG24W results in
* RC 8 on pre-script and post-script
* configuration displays
*
* DESCRIPTION DETAIL:
*
* During GDDR scripts, warning message GDDUG24W could result
* in an RC 8 on the pre-script and post-script configuration
* displays, for example:
*
* GDDUG24W 2 external RDF groups indicate SRDF/A active
* GDDR639I GDDR Completed pre-script configuration display
* with rc 8
*
* This is simply a messaging issue, as a non-zero RC on the
* configuration displays does not affect the outcome of the
* script.
*
* PROBLEM RESOLUTION:
*
* Warning message GDDUG24W will now result in an RC 4 on the
* configuration displays, as expected.
*
* MODULES: GDDRMCMD
*
* ------------------------------------------------------------
*
* PROBLEM FIXED: GDDR-3460 GDDR-3472
* USERS AFFECTED: GDDR users
* PROBLEM DESCRIPTION: ABENDS067-04 upon GDDRMAIN startup due
* to another GDDR instance not shutting
* down cleanly
*
* DESCRIPTION DETAIL:
*
* An S067-04 abend could occur upon GDDRMAIN startup at
* GDDRMAIN offset 000006AC (data at PSW 4038B219 02009540
* 50E8B219) if another GDDR instance was not shut down
* cleanly. This causes GDDRMAIN to terminate.
*
* PROBLEM RESOLUTION:
*
* An S067-04 abend should no longer occur upon GDDRMAIN
* startup if another GDDR instance was not shut down cleanly.
*
* In addition, the GDDRMAIN ESTAE routine has been improved to
* ensure that GDDRMAIN is shut down cleanly in case of an
* abend.
*
* MODULES: GDDRMAIN
* GDDRMCMD
*
* ------------------------------------------------------------
*
* PROBLEM FIXED: GDDR-3499
* USERS AFFECTED: GDDR users
* PROBLEM DESCRIPTION: New PRIMARY command to display primary
* C-system name
*
* DESCRIPTION DETAIL:
*
* A new command is needed to display the primary C-system name
* from any system in the GDDR-plex, including managed systems.
*
* PROBLEM RESOLUTION:
*
* A new PRIMARY command has been created to display the
* primary C-system name from the point-of-view of one or more
* C-systems. By default, the point-of-view from all C-systems
* is shown. The SYSTEM parameter may be used to narrow the
* scope to the specified C-system, and the SITE parameter may
* be used to narrow the scope to the C-system at the specified
* site. This command may be issued from any system where
* GDDRMAIN is active, including managed systems. It can be
* issued as a GDDRMAIN modify command (e.g., F GDDRMAIN,PRI),
* as a Perform Health Check panel primary command (e.g., PRI),
* or using the GDDRMCMD batch interface (see GDDRMCMD in
* SAMPLIB).
*
* Syntax:
*
* PRImary
* [,SITE={DC1|DC2|DC3|DC4}]
* [,SYStem={<system_name>|LoCaL|ALL}]
* [,TiMeOut=<seconds>]
* [,CONsole[={Yes|No}]]
* [,SysMSG[={Yes|No}]]
* [,SysPRinT[={Yes|No}]]
* [,DeBuG[={Yes|No}]]
*
* Example:
*
* GDDUC04I Primary C-system as seen from the indicated
* site/system
* ---------------------------------------------------------
* Site System Value
* ---- -------- -----------------------------------------
* DC1 N247 N247
* DC2 X99 N247
* DC3 X98 N247
* ---------------------------------------------------------
*
* MODULES: GDDRMCMD
* GDDRMCON
*
* ------------------------------------------------------------
++PTF(GD60005) REWORK(2023012) .
++VER(Z038) FMID(GDDR600)
/*
*-------------------------------------------------------------
* PROBLEM DESCRIPTION(S):
* ------------------------------------------------------------
*
* PROBLEM FIXED: GDDR-3463 GDDR-3465
* USERS AFFECTED: GDDR users
* PROBLEM DESCRIPTION: ABENDS0E0-29 upon GDDRMAIN startup or
* ABENDS0E0-28 upon GDDRMAIN shutdown
*
* DESCRIPTION DETAIL:
*
* An S0E0-29 abend could occur upon GDDRMAIN startup in the
* HBM (heartbeat monitor) subtask at GDDREVMI offset 0005AF74
* (data at PSW 183158F0 0010D507 3000F154). This causes the
* HBM subtask to terminate and leaves GDDRMAIN without
* heartbeat monitoring capabilities.
*
* In addition, an S0E0-28 abend could occur in GDDRRPT upon
* GDDRMAIN shutdown at GDDRMAIN offset 0006EAB2 (data at PSW
* D24FD37A 1000D207 D37D5004).
*
* PROBLEM RESOLUTION:
*
* An S0E0 abend should no longer occur upon GDDRMAIN startup
* in GDDREVMI or upon GDDRMAIN shutdown in GDDRRPT.
*
* MODULES: GDDREVMI
* GDDRRPT
Affected Products
Geographically Dispersed Disaster Restart (GDDR)Article Properties
Article Number: 000203766
Article Type: Solution
Last Modified: 07 Aug 2025
Version: 3
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.