Numéro d’article: 000121674

How to perform interface range commands on 7000, 8000, 8100, M6220, M6348, M8024-K N2000, N3000 and N4000 series switches

Résumé: How to set up interface range command on Dell n series PowerConnect switches

Cet article a peut-être été traduit automatiquement. Si vous avez des commentaires concernant sa qualité, veuillez nous en informer en utilisant le formulaire au bas de cette page.

Contenu de l’article

Instructions

Article Summary: This article explains how to configure multiple interfaces at the same time.

To configure multiple interfaces at the same time, you have to go into an interface range command.

Run the following commands to enter a range of interfaces.

console>enable

console#configure

For consecutive ports, the following example uses Gigabit Ethernet ports 1-5 on Unit 1

console(config)#interface range gi1/0/1-5

For non-consecutive ports, the following example uses Gigabit Ethernet ports 48 on Unit 1 and 2

console(config)#interface range gi1/0/48,gi2/0/48

Note: Notice that starting after range there are no more spaces in the rest of the command syntax for both examples

Note: To verify the way the ports are defined on your switch, you can run a console#show interfaces status

Below is an example to configure the consecutive ports 1 through 5, as well as 8 and 9.

console(config)#interface range gi1/0/1-5,gi1/0/8,gi1/0/9

Note: You may configure different interface types at the same time, such as a Gigabit Ethernet, and 10-Gigabit Ethernet interface

Propriétés de l’article

Produit concerné

PowerSwitch N3000 Series, PowerConnect 7024, PowerConnect 7024F, PowerConnect 7024P, PowerConnect 8024, PowerConnect 8024F, PowerConnect 8100 Series, PowerConnect M6220, PowerConnect M6348, PowerConnect M8024, PowerConnect M8024-K

Dernière date de publication

21 فيفري 2021

Version

Type d’article

How To

Haut de la page

Bienvenue

Bienvenue dans l’univers Dell