Dell EMC PowerEdge R7415 Installation and Service Manual

Removing the LOM riser card

1. Using a Phillips #2 screwdriver, remove the screws that secure the LOM riser card to the system board.
2. Release the two blue side plastic snaps holding the LOM riser card.
3. Hold the LOM riser card by the edges on either side, and lift to disconnect the card from the connector on the system board.
4. Slide the LOM riser card towards the front of the system until the Ethernet connectors or the SFP+ are clear of the slot in the back panel.

   

5. Lift the LOM riser card out of the system.
6. Remove the LOM riser bracket.
   1. Using a Phillips #2 screwdriver, remove the screw that secures the bracket to the chassis.
   2. Slide the bracket out of the slot on the chassis.

      

7. If the LOM riser card is not being replaced immediately, install the LOM filler bracket.
   1. Insert and slide the LOM filler bracket into the slot on the chassis.
   2. Using a Phillips #2 screwdriver, secure the LOM filler bracket to the chassis with a screw