Dell Precision Tower 3620 Owner's Manual

Installing the PCIe Solid State Drive SSD

  • NOTE: The PCIe SSD card is shipped with the following components:
  1. PCIe SSD card
  2. Thermal Pad
  3. Screw
  1. Follow the procedure in Before Working Inside Your Computer .
  2. Remove the:
    1. cover

    2. hard drive

    3. optical drive

  3. Peel the blue adhesive tape from the thermal pad. Figure displaying removing the blue adhesive tape.
  4. Place the thermal pad in the slot on the system board and peel the pink adhesive tape [1,2]. Figure displaying placing the thermal pad on the system board
  5. Slide the PCIe SSD card into the slot and tighten the screw to secure the card to the system board [1,2]. Figure displaying installing the PCIe SSD card into the slot.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\