Dell Precision Tower 3620 Owner's Manual

Installing the power switch

  1. Align and slide the power switch module into the slot on the chassis until it clicks into place.
    • NOTE: Ensure that the power switch cable is routed correctly through the cable routing clips on the system chassis.
  2. Connect the power switch cable to the connector on the system board.
  3. Install the:
    1. Optical drive module

    2. HDD assembly

    3. Front bezel

    4. Side cover

  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\