Dell Precision Tower 3620 Owner's Manual

Removing the system board

  1. Follow the procedure in Before Working Inside Your Computer .
  2. Remove the:
    1. cover

    2. front bezel

    3. memory module

    4. hard drive

    5. expansion card(s)

    6. heat sink

  3. Disconnect all the cables connected to the system board. Figure displaying disconnecting cable.
  4. To remove the system board:
    1. Remove the screws that secure the system board to the computer [1].
    2. Slide the system board and lift it away from the computer [2].
    Figure displaying removing the system board

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\