Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

PDF

Install or update a RPM driver package using the KMOD support

Prerequisites

NOTE:This procedure is applicable for Red Hat Enterprise Linux 7.x and higher.

About this task

Perform the following steps to install the RPM package with KMOD support:

Steps

  1. Uncompress the gzipped tarball driver release package.
  2. Install the driver package using the command: rpm –ihv kmodmegaraid_ sas-<version>.rpm.
    NOTE:Use rpm -Uvh <package name> when upgrading an existing package.
  3. If the previous device driver is in use, you must reboot the system for the updated driver to take effect.
  4. Verify the loaded driver version by running the following command: modinfo megaraid_sas.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\