Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products

Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

Select boot mode

Steps

  1. Enter the Dell PERC 11 Configuration Utility. See Navigate to Dell PERC 11 configuration utility.
  2. Click Main Menu > Controller Management > Advanced Controller Properties.
  3. In the Controller Properties section, select boot mode from the Boot Mode drop-down box.
    The following lists of boot mode options appear:
    Table 1. Boot mode optionsThis table describes the boot mode options.
    Option Description
    Stop on errors The system stops during boot for errors which require attention from the user to rectify the issue.
    Pause on errors System pauses during boot to show errors but continue boot after it times out. Only critical events with an infinite timeout halt boot and require the user’s attention to correct the issue.
    NOTE:In UEFI BIOS mode, errors with timeouts do not appear during boot. It is designed to arise only in legacy BIOS mode.
    NOTE:By default, the boot mode option is set to pause on errors.
  4. Click Apply Changes.
    The boot mode operation is completed successfully.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\