CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Steps
Align the screw holes on the PDB with the
screw holes on the PDB bracket.
Install the three screws to secure the PDB
to the bracket.
Holding it by the handle, position the PDB
bracket so that the two PDB edge connectors align with the connectors
on the system board and the power pass-through board.
Aligning the slot on the PDB bracket with the
metal standoffs on the chassis wall, slide the PDB into the connectors
until firmly seated.
When firmly seated, the spring-loaded screw
on the PDB bracket aligns with the screw hole on the power supply
unit (PSU) cage.
Tighten the spring-loaded screw to secure
the PDB bracket to the PSU cage.
Close the system.
If applicable, place the system upright on
a flat, stable surface and rotate the system feet outward.
Reinstall the PSUs.
If removed, reinstall the hard drives and server
modules.
Reconnect the enclosure to its electrical outlet
and turn the enclosure on, including any attached peripherals.
Turn on the server modules using the operating
system commands or the CMC.
If applicable, install the front bezel.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\