Skip to main content
Contact Us

Latitude 5455 Owner's Manual

PDF

Installing the coin-cell battery

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the coin-cell battery and provide a visual representation of the installation procedure.
Figure 1. Installing the coin-cell battery
Image: Installing the coin-cell battery

Steps

  1. Adhere the coin-cell battery on to the coin-cell battery slot on the palm-rest and keyboard assembly.
  2. Route the coin-cell battery cable through the routing guides on the palm-rest and keyboard assembly.
  3. Connect the coin-cell battery cable to the connector (JRTC1) on the system board.
  4. Route the I/O-board cable through the routing guides and connect it to the connector (JIO1) on the system board.
  5. Connect the I/O-board cable to the connector (JIO1) on the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\