- Notes, cautions, and warnings
- Views of Latitude 5455
- Set up your Latitude 5455
- Specifications of Latitude 5455
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Camera
- Touchpad
- Power adapter
- Battery
- Fingerprint reader
- Display
- GPU—Integrated
- External display support
- Sensor
- Hardware security
- Operating and storage environment
- Dell support policy
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locating the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
- Revision history
Latitude 5455 Owner's Manual
Installing the fan
Prerequisites
About this task
Steps
- Place and align the fan, along with the fan cable, in the slot on the palm-rest and keyboard assembly. CAUTION: Avoid touching the fan blades to prevent damage.
- Align the screw holes on the fan with the screw holes on the palm-rest and keyboard assembly.
- Replace the three screws (M2x2.5) that secure the fan to the palm-rest and keyboard assembly.
- Connect the fan cable to the connector (JFAN1) on the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\