Skip to main content

Latitude 5455 Owner's Manual

Installing the palm-rest and keyboard assembly

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image shows the palm-rest and keyboard assembly before all the components in the post-requisites steps have been installed. Place the palm-rest and keyboard assembly on a flat surface.

Figure 1. Palm-rest and keyboard assembly
Image: Palm-rest and keyboard assembly

Next steps

  1. Install the system board.
  2. Install the power button.
  3. Install the I/O board.
  4. Install the touchpad assembly.
  5. Install the display assembly.
  6. Install the WLAN-antenna module.
  7. Install the I/O-board cable.
  8. Install the heat sink.
  9. Install the battery.
  10. Install the fan.
  11. Install the speakers.
  12. Install the SSD.
  13. Install the base cover.
  14. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\