Skip to main content

Latitude 5455 Owner's Manual

Installing the power button

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the power button and provide a visual representation of the installation procedure.
NOTE:The power button on your computer may vary depending on the configuration which you have ordered.
Figure 1. Installing the power button
Image: Installing the power button
Figure 2. Installing the power button with fingerprint reader
Image: Installing the power button with fingerprint reader
Using the alignment post, place the power button in the slot on the palm-rest and keyboard assembly.
NOTE:Ensure that the tab is inserted inside the slot and not on top of it. Avoid creating a gap, which may damage the I/O board or the base cover.
Figure 3. Installing the power button
Image: Installing the power button

Next steps

  1. Install the I/O board.
  2. Install the display assembly.
  3. Install the base cover.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\