Skip to main content
Contact Us

Latitude 5455 Owner's Manual

PDF

Installing the speakers

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the speakers and provide a visual representation of the installation procedure.
Figure 1. Installing the speakers
Image: Installing the speakers

Steps

  1. Using the alignment posts, place the right and left speakers into their slots on the palm-rest and keyboard assembly.
    NOTE:Ensure that the rubber grommets are seated into the slot and installed on the speakers properly.
    Figure 2. Installation of rubber grommets
    Image: Installation of rubber grommets
  2. Route the right-speaker cable through the routing guides on the palm-rest and keyboard assembly.
  3. Adhere the tape on the speaker cable to the coin-cell battery.
  4. Connect the right-speaker cable to the connector (JSPK2) on the system board.
  5. Connect the left-speaker cable to the connector (JSPK1) on the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\