Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Alienware Area-51m R2 Service Manual

Installing the card-reader board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the card-reader board and provides a visual representation of the installation procedure.

Image: Installing the memory module

Steps

  1. Place the card-reader board in the slot on the palm-rest assembly.
  2. Align the screw holes on the card-reader board with the screws holes on the palm-rest assembly.
  3. Replace the three screws (M2.5x2.5) that secure the card-reader board to the palm-rest assembly.
  4. Route the card-reader board cable through the routing guides on the computer base.
  5. Connect the card-reader board cable to the system board.

Next steps

  1. Install the computer base.
  2. Install the rear-I/O cover.
  3. Install the solid-state drive in M.2 slot two.
  4. Install the wireless card.
  5. Install the battery.
  6. Install the base cover.
  7. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\