- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Technical overview
- Removing the base cover
- Replacing the base cover
- Removing the hard drive
- Replacing the hard drive
- Removing the top cover
- Replacing the top cover
- Removing the bottom USB-port
- Replacing the bottom USB-port
- Removing the power-button board
- Replacing the power-button board
- Removing the processor fan
- Replacing the processor fan
- Removing the processor heat-sink
- Replacing the processor heat-sink
- Removing the video-card fan
- Replacing the video-card fan
- Removing the memory modules
- Replacing the memory modules
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the processor
- Replacing the processor
- Removing the front-panel light board
- Replacing the front-panel light board
- Removing the wireless card
- Replacing the wireless card
- Removing the antenna modules
- Replacing the antenna modules
- Removing the system board
- Replacing the system board
- Removing the coin-cell battery
- Replacing the coin-cell battery
- BIOS setup program
- Flashing the BIOS
- Technology and components
Alienware Alpha R2 Service Manual
Procedure
- Slide the USB port under the tab on the chassis.
- Replace the screw that secures the USB port to the chassis.
- Align and slide the tabs on USB-port bracket in the slots on the chassis.
- Replace the screw that secures the USB-port bracket to the chassis
- Route the USB-port cable through the routing guides on the chassis and slide the cable through the cable-routing hole on the chassis.
- Turn the computer over.
- Connect the USB-port cable to the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\