Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

XPS 15 Service Manual

PDF

Procedure

  • NOTE: The touch-screen cable is available only on laptop configurations with touch displays.
  1. Remove the screw (M2x2) that secures the display-cable bracket to the system board.
  2. Disconnect the touch-screen cable and display cable from the system board.
  3. Peel off the tape and remove the touch-screen cable from the routing guides on the fan.
    Figure 1. Disconnecting the cables Image: Disconnecting the cables
    1. touch-screen cable (optional)
    2. tape
    3. display-cable bracket
    4. screw
    5. display cable
  4. Turn the computer over and open the display at an angle of 90 degrees.
  5. Rotate the computer and place it on the edge of the table in a position that allows access to the screws on the display hinges.
  6. Remove the six screws (M2.5x5) that secure the display hinges to the palm-rest assembly.
  7. Carefully lift the display assembly from the palm-rest assembly
    Figure 2. Removing the screws that secure the display hinges to palm-rest assembly Image: Removing the screws that secure the display hinges to the palm-rest assembly
    1. palm-rest assembly
    2. screws (6)
    3. display hinges (2)
    4. display assembly
  8. Carefully place the display assembly on a clean, flat surface.
    Figure 3. Display assemblyImage: Display assembly
    1. display assembly

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\