Dell PowerEdge R420 Systems Owner's Manual

PDF

Assigning A System And/Or Setup Password

  • NOTE: The password jumper enables or disables the System Password and Setup Password features. For more information on the password jumper settings, see System Board Jumper Settings.

You can assign a new System Password and/or Setup Password or change an existing System Password and/or Setup Password only when the password jumper setting is enabled and Password Status is Unlocked. If the Password Status is Locked, you cannot change the System Password.

If the password jumper setting is disabled, the existing System Password and Setup Password is deleted and you need not provide the system password to log on to the system.

To assign a system and/or setup password:
  1. To enter System Setup, press <F2> immediately after a power-on or reboot.
  2. In the System Setup Main Menu, select System BIOS and press <Enter>. The System BIOS screen is displayed.
  3. In the System BIOS screen, select System Security and press <Enter>. The System Security screen is displayed.
  4. In the System Security screen, verify that Password Status is Unlocked.
  5. Select System Password , enter your system password, and press <Enter> or <Tab>. Use the following guidelines to assign the system password:
    • A password can have up to 32 characters.
    • The password can contain the numbers 0 through 9.
    • Only lower case letters are valid, upper case letters are not allowed.
    • Only the following special characters are allowed: space, (”), (+), (,), (-), (.), (/), (;), ([), (\), (]), (`).
    A message prompts you to re-enter the system password.
  6. Re-enter the system password that you entered earlier and click OK.
  7. Select Setup Password, enter your system password and press <Enter> or <Tab>. A message prompts you to re-enter the setup password.
  8. Re-enter the setup password that you entered earlier and click OK.
  9. Press <Esc> to return to the System BIOS screen. Press <Esc> again, and a message prompts you to save the changes.
    • NOTE: Password protection does not take effect until the system reboots.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\