In this configuration,
the individual node network adapters are isolated from the other nodes
in the sled. Any inter-node network traffic is routed to the external
switches before being directed back to the destination nodes. The
external ports on the embedded network switch (or switches) are configured
into a single trunk or LAG for throughput and redundancy. The external
rack switches are on the same network in this configuration.
NOTE: The network adapter
isolation configuration also supports uplinks of all four ports to
a single external rack switch.
This configuration
enhances security, as security features like firewalls are installed
in the external rack switches, and is useful in multi-tenant configurations.
Figure 1. Network adapter
isolation configuration
Table 1. Network adapter
isolation configuration icon descriptionThe following table describes about the network
adapter isolation configuration icons.
Icon
Description
Network path
Single trunk configuration or LAG
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
