Alienware x15 R2 Service Manual

PDF

Installing the battery

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the battery and provides a visual representation of the installation procedure.

Image: Installing the battery

Steps

  1. Using the alignment posts, place the battery on the palm-rest and keyboard assembly.
  2. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
  3. Replace the four screws (M2x4) that secure the battery to the palm-rest and keyboard assembly.
  4. Route the battery cable through the routing guides on the fan and connect the battery cable to the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\