Alienware x15 R2 Service Manual

PDF

Installing the M.2 2280 solid-state drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

NOTE:The following procedure applies only to computers shipped with an M.2 2280 solid-state drive.
NOTE:The M.2 card installed on M.2 slot will depend on the configuration ordered. Supported card configurations:
  • M.2 2230 solid-state drive + 2230 mounting bracket
  • M.2 2280 solid-state drive

The following image(s) indicate the location of the solid-state drive and provides a visual representation of the installation procedure.

Image: Installing the solid-state drive

Steps

  1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
  2. Slide the solid-state drive into the solid-state drive slot.
  3. Slide the solid-state drive thermal shield into the solid-state drive slot.
  4. Align the screw hole on the solid-state drive thermal shield with the screw hole on the solid-state drive and palm-rest and keyboard assembly.
  5. Replace the screw (M2x3) that secures the M.2 2280 solid-state drive thermal shield to the solid-state drive and palm-rest and keyboard assembly.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\