Alienware x15 R2 Service Manual

PDF

Installing the palm-rest and keyboard assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.

Image: Installing the palm-rest and antenna assembly

Steps

To install the palm-rest and keyboard assembly, perform the postrequisites.

Next steps

  1. Install the power button.
  2. Install the I/O-board.
  3. Install the system board.
    NOTE:The system board can be removed and installed along with the heat sink. This simplifies the removal and installation procedure and avoids breaking the thermal bond between the system board and heat sink.
  4. Install the keyboard-controller board.
  5. Install the touchpad.
  6. Install the speakers.
  7. Install the display assembly.
  8. Install the headset port.
  9. Install the power-adapter port.
  10. Install the rear I/O-cover.
  11. Install the fans.
  12. Install the solid-state drive bracket.
  13. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
  14. Install the wireless card.
  15. Install the battery.
  16. Install the base cover.
  17. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\