Alienware x15 R2 Service Manual

PDF

Installing the rear I/O-cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the rear I/O-cover and provides a visual representation of the installation procedure.

Image: Installing the rear I/O-cover

NOTE:To avoid damaging your computer, ensure that the Tron-light cable is not pinched when sliding the rear I/O-cover into palm-rest and keyboard assembly.

Steps

  1. With the correct orientation, slide the rear I/O-cover into the palm-rest and keyboard assembly, and snap it into place.
  2. Slide the left and right Tron-light cables into their respective connectors on the system board and close the latches to secure the cables.
    CAUTION:Do not pull at the bend points of the Tron-light cables and check for damage while removing and installing.
  3. Replace the two screws (M2.5x9) that secure the rear I/O-cover to the palm-rest and keyboard assembly.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\