Alienware x15 R2 Service Manual

PDF

Removing the battery cable

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
NOTE:If battery is disconnected from system board for service, then there is a delay during boot as the computer undergoes RTC battery reset.

About this task

The following images indicate the location of the battery cable and provide a visual representation of the removal procedure.

Image: Removing the battery cable

Steps

  1. Turn the battery over and peel the battery cable from the battery.
  2. Disconnect the battery cable from the connector on the battery.
  3. Lift the battery cable off the battery.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\