Dell Canvas Pen User's Guide

Customizing the Pen

Go to Start > Dell Canvas > Canvas Pen in the Windows operating system and customize settings for the Pen.

The following settings are available in the Canvas Pen control panel settings:

Table 1. Can Pen control panel settings. The following table lists different functional specifications of the Pen available in the control panel:
FunctionDescription
Tilt sensitivity

Allows you to adjust the Tilt sensitivity of your Pen. It determines how far you can tilt the tool to produce maximum tilt effect. You need to tilt the pen less, at high sensitivity than at low sensitivity. Drag the slider to increase or decrease the Tilt.

Top Barrel Button

The option Erase is selected by default. You can customize the setting by choosing a different function from the drop-down list. For more information about different functions in the list, see button functions.

Bottom Barrel Button

The option Barrel button is selected by default. You can customize the setting by choosing a different function from the drop-down list. For more information about different functions in the list, see button functions.

Hover Click

Click the check box to hold the pen tip close to the screen and press the side switch to perform a set function.

Pen Tip Options
Pen tip sensitivity

Allows you to adjust the click pressure and pressure-sensitivity. Drag the slider to change it to the required setting.

Calibrate

You can calibrate the Pen display to align the screen cursor with the position of the pen on the Canvas screen. For more information, see calibrating the pen display.

Configure Displays

Allows you to configure the display settings.

Show Ripple Effect

To enable visual feedback for the pen, click the checkbox.

Restore default settings

Restores the changes to the default settings


  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\