Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.11 Cyber Recovery User Guide

Recovering PowerProtect Data Manager data

Use a point-in-time (PIT) copy to rehydrate PowerProtect Data Manager data in the Cyber Recovery vault.

You can initiate a PowerProtect Data Manager recovery by using the Cyber Recovery UI or the CRCLI. You then complete the recovery from the PowerProtect Data Manager application in the Cyber Recovery vault.

NOTE You can only run one recovery job per application at a time.

When you initiate a recovery, the Cyber Recovery software prepares your environment so that you can run a PowerProtect Data Manager recovery from the application console. As part of this process, the software creates a production DD Boost username and password on the DD system, and reboots the PowerProtect Data Manager appliance. It also takes a VM snapshot of the PowerProtect Data Manager appliance that you use to revert the PowerProtect Data Manager software after you complete the recovery.

After a successful recovery, you can run a recovery check to ensure that a copy can be recovered.

During the check, the state of the backup copy shows as In-progress. When the recovery check is completed successfully, the data backup copy shows as Recoverable.

If the recovery check fails, the state of the backup copy shows as Failed. Alerts in the dashboard and an email message notify you of the state. The alerts are either:

  • Warning—The backup copy is partially recoverable.
  • Critical—The backup copy is unrecoverable.

  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\