The SAP HANA database server automatically performs periodic backups of the redo logs for a database.
PowerProtect Data Manager does not perform any log or catalog backups. You cannot perform the log backups with any backup commands.
NOTE Since the log backups and catalog backups are automatically triggered by SAP HANA, these backups continue to be performed even when the
PowerProtect Data Manager protection policy is disabled.
You can use the SAP HANA Studio GUI to configure the frequency of automatic log backups and whether the Backint interface is used for the log backups.
To configure the automatic backups of SAP HANA redo logs, complete the required settings in SAP HANA Studio.
On the
Configuration tab of the
Backup editor, complete the settings in the
Log Backup Settings group box:
Select
Enable Automatic Log Backup.
For
Destination Type, select
Backint.
For
Backup Interval, specify the log backup interval. Type the numeric value in the text box, and then select the unit of time, such as
Minutes, from the menu.
NOTE The recommended log backup interval is 30 minutes.
The following figure shows a configuration example in SAP HANA Studio.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\