PowerProtect Data Manager 19.9 Azure Deployment Guide
Configure network traffic rules
Once the PowerProtect Data Manager instance is deployed, it is recommended to change the default network traffic rules that allow all inbound and outbound connections.
About this task
NOTE Even if you specified a port range during the deployment of the
PowerProtect Data Manager instance, outbound ports remain unrestricted unless you change the outbound rules.
Steps
- From the Azure portal, navigate to , and click the entry for the PowerProtect Data Manager virtual appliance.
- From the pane for the virtual appliance, click Networking.
-
From the
Network Interface pane, click either
Inbound port rules or
Outbound port rules, and change specific network traffic rules.
NOTE For more information, see the PowerProtect Data Manager Security Configuration GuideCAUTION Do not use IP addresses that belong to the 172.24.0.192/26 subnet. IP addresses in the 172.24.0.192–172.24.0.255 range are used for Docker network configuration, and unexpected results can occur if they are also used by PowerProtect Data Manager.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\