PowerProtect Data Manager 19.9 Cloud Disaster Recovery User Guide

PDF

Add a Cloud DR type Service Level Agreement

The Policy type SLA sets the SLA for the entire policy.

About this task

Do the following steps to add Policy type SLA:

Steps

  1. Select Protection > SLA Compliance.
    The SLA Compliance window appears.
  2. Click Add.
    The Add Service Level Agreement window appears.
  3. Select Cloud DR in the Type section, and then click Next.
  4. In the Objectives section, specify the SLA name.
  5. If applicable, select the Recovery Point Objective (RPO), and then set the duration.
    The RPO is defined in RecoverPoint for Virtual Machines RPO setting of each cloud copy.
  6. Click Finish.
    The SLA appears on the SLA Compliance page.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\