PowerProtect Data Manager 19.9 Cloud Disaster Recovery User Guide

Add new storage target

When you add a primary backup, you can add a storage target instead of selecting an existing storage target.

1. Go to Infrastructure > Storage, and click Add in the Protection Storage Name tab.
   The Add Storage dialog is displayed.
2. Select the appropriate Storage Type from the following options.
   • PowerProtect DD System
   • PowerProtect DD Management Center
   If the system supports High Availability mode, enable the High Availability checkbox.
3. Specify the following fields.
   • Name - Description of the system
   • Address - FQDN or IP address of the system
   • Port
4. In the Host Credentials section, the credentials of the system are selected by default.
   Perform the following steps to configure a different host credential.
   1. Select Add Credentials from the Host Credentials drop-down list.
      The Add Credentials dialog box is displayed,
   2. Specify the following fields:
      • Name - Domain name
      • User Name - Domain username
      • Password - Domain password
   3. Click Save to add host credentials.
5. Click Verify to verify the certificate of the system.
6. Click Save to add the new storage target.