PowerProtect Data Manager 19.9 File System Agent User Guide

ddfsrc command with input file specified

ddfsrc -h DFA_SI_DEVICE_PATH=Protection storage unit -h DFA_SI_DD_HOST=Protection storage system IP address -h DFA_SI_DD_USER=Protection storage system username -S savetime-value -I path-of-file-containing-list-of-files-for-restore -i R -d destination-path-for-restoring-files

The following steps provide more detail:

1. Use the ddfsadmin command to list all the available backups. If you know the save set ID of the backup from which you want to restore, skip this step.

   For example, the following command lists all backups taken in the last 55 days.

   [root@XXXX ~]# ddfsadmin backup query -local -t=55d

2. Create an input file that contains the list of files to restore.

   For example:

   [root@XXXX ~]# cat flr.txt

   /new_ext3/file.txt

   The flr.txt file specifies a single file to restore (file.txt).

3. Run the ddfsrc command. Ensure that you provide the complete path to the input file that you created.
   NOTE Do not provide a relative path. If you provide a relative path, the command fails.

   For example:

   ddfsrc -h DFA_SI_DEVICE_PATH=Protection storage unit -h DFA_SI_DD_HOST=Protection storage system IP address -h DFA_SI_DD_USER=Protection storage system username -S savetime-value -I /root/flr.txt -d destination-path-for-restoring-files

   where savetime-value is the save set ID identified in step 1.