NOTE: Note the routing of all cables as you remove them so that you can route them correctly while you are replacing the power-supply unit.
About this task
The following images indicate the location of the power-supply unit and provides a visual representation of the removal procedure.
Steps
Lay the computer on the right side.
Remove the two screws (#6-32) that secure the power-supply unit
cover to the chassis.
NOTE: Only the computer with clear doors are shipped with power-supply unit cover. This step is applicable only for computers shipped with power-supply unit cover.
Slide and lift the power-supply unit cover off the power-supply unit.
Remove the three screws (#6-32) that secure the power-supply unit
to the chassis.
Disconnect the power cables from the system board and remove them from the routing guides on the chassis.
Press the securing clip and slide the power-supply unit away from the back of the chassis.
Lift the power-supply unit off the chassis.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\