Inspiron 14 Plus 7440 Owner's Manual

PDF

Installing the I/O-board and USB-board cable

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

NOTE:If either the system board or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure that thermal conductivity is achieved.

The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.

Figure 1. Installing the I/O-board and USB-board cable
Image: Installing the I/O-board and USB-board cable

Steps

  1. Replace the I/O-board and USB-board cable on the palm-rest and keyboard assembly.
  2. Connect the I/O-board cable to its connector on the system board and close the latch.
  3. Connect the I/O-board cable to its connector on the I/O board and close the latch.

Next steps

  1. Install the USB board.
  2. Install the heat sink.
  3. Install the fan.
  4. Install the base cover.
  5. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\