Inspiron 14 Plus 7440 Owner's Manual

PDF

Installing the power-adapter port

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the power-adapter port and provides a visual representation of the installation procedure.

Figure 1. Installing the power-adapter port
Image: Installing the power-adapter port

Steps

  1. Place the power-adapter port into the power-adapter port slot on the palm-rest and keyboard assembly.
  2. Route the power-adapter port cable through the routing guide on the palm-rest and keyboard assembly.
  3. Connect the power-adapter port cable to its connector on the system board.
  4. Adhere the tape that secures the power-adapter port cable to the power-adapter port cable connector on the system board.
  5. Close the display hinge and align the screw holes on the display hinge with the screw holes on the palm-rest and keyboard assembly.
  6. Replace the two screws (M2.5x5) that secure the left display-assembly hinge to the palm-rest and keyboard assembly.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\