Latitude 7420/Latitude 7420 2-in-1 Service Manual

PDF

Installing the base cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the base cover and provides a visual representation of the installation procedure.

Place the base cover and snap the latches.

Tighten the eight captive screws.

Steps

  1. Align and place the base cover on the computer, and snap the base cover latches into place.
  2. Tighten the eight captive screws to secure the base cover to the computer.

Next steps

  1. Install the microSD card.
  2. Follow the procedure in after working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\