Latitude 7420/Latitude 7420 2-in-1 Service Manual

PDF

Removing the solid-state drive(SSD)

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the microSD card.
  3. Remove the base cover.

About this task

The following images indicate the location of the solid-state drive(SSD) and provide a visual representation of the removal procedure.

Figure 1. Removing the SSD (for computers with WWAN support). Removing the SSD(for computers with WWAN support)
Removing the SSD(for computers with WWAN support)
Figure 2. Removing the SSD (for computers with WLAN-only support). Removing the solid-state drive (for computers with WLAN-only support)
Removing the solid-state drive (for computers with WLAN-only support)

Steps

  1. For computers with WWAN support, remove the screw (M2x2) that secures the SSD shield to the system board.
  2. For computers with WLAN-only support, remove the two screws (M2x2) that secure the SSD shield to the system board.
  3. Slide and lift the SSD shield from the SSD.
  4. Slide and remove the SSD from the M.2 slot on the system board.
    NOTE:The SSD thermal shield includes a thermal pad that is attached to the bottom of the shield. Ensure that you adhere the thermal pad back to its location if it is displaced during the removal procedure.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\