Latitude 7455 Owner's Manual

PDF

Installing the battery

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the battery and provide a visual representation of the installation procedure.
Figure 1. Installing the battery
Image: Installing the battery

Steps

  1. Align the screw holes on the battery with the screw holes on the palm-rest and keyboard assembly.
  2. Tighten the five captive screws that secure the battery to the palm-rest and keyboard assembly.
  3. Connect the battery cable to the connector (JBATT1) on the system board.

Next steps

  1. Install the base cover.
  2. Install the SIM card, if applicable.
  3. Follow the procedure in After working inside your computer.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\