Latitude 7455 Owner's Manual

PDF

Removing the battery

CAUTION: The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the SIM card, if applicable.
  3. Remove the base cover.

About this task

CAUTION:Removing the battery resets the BIOS setup settings to default. It is recommended that you note the BIOS setup settings before removing the battery.
The following images indicate the location of the battery and provide a visual representation of the removal procedure.
Figure 1. Removing the battery
Image: Removing the battery

Steps

  1. Disconnect the battery cable from the connector (JBATT1) on the system board (if not disconnected earlier).
  2. Loosen the five captive screws that secure the battery to the palm-rest and keyboard assembly.
  3. Lift the battery off the palm-rest and keyboard assembly.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\