Dell Wyse ThinOS Version 8.6.1 INI Reference Guide

PDF

Peripheral settings for wnos.ini files only

The following table contains the parameters used for configuring peripheral settings such as keyboard, monitor, mouse, and printer. The defaults values are underlined.

Table 1. Peripheral Settings: wnos.ini files onlyTable contains the parameters used for configuring peripheral settings such as keyboard, monitor, mouse, and printer.
ParameterDescription
DEVICE_SECURITY=white_list/black_list

vid_pid=[vvvv,pppp]

class=name/[cc,ss,pp]

  1. When DEVICE_SECURITY=white_list is set, the security is in high level, and you need to add all the devices (on board devices including Wyse 3020 thin client with ThinOS (T10D)'s netcard, and internal hub) to the list that you want to use, and all other devices are denied when the device is plugged-in.
  2. When DEVICE_SECURITY=black_list is set, the security is mid-level, and customer can add the device which is not present in the list.

  3. About key value: all the value are hex, and vid_pid = 0xvvvvpppp, class value is =0xccsspp; where,
    • vvvv=device vendor id
    • pppp=device product id
    • cc= device interface class
    • ss=device interface subclass
    • pp=device interface protocol
  4. Class name is abbreviation for the defined class. Valid names are listed here:{Audio, CDC_control, HID, Pysical, Image, MASS_STORAGE, Hub, CDC_Data, Smart_Card, Content_Security, Video, Personal_Healthcare, AudioVideo, Billboard, Diagnostic_Device, Wireless, Miscellaneous, Application, VendorSpecific}. For detailed information, refer: www.usb.org/developers/defined_class.

  5. The max number of devices/class table is 16.

    For Example:

    DEVICE_SECURITY=white_list class=HID class=Audio class=Video

    DEVICE_SECURITY=black_list vid_pid=0x0B0E2000 class=0x030101.

PrinterMap=a text file name or possibly URL.

A text file to be included to define printer mappings. Each line in the file is of format Printer Identification=Printer Driver Name. For example: HL-1240 Series=HP LaserJet.

ThinPrintEnable={no, yes}

[Port=port number]

Default is yes.

ThinPrintEnable — Yes/no option to enable the thinprint client.

port—The TCP port of the thinprint client. The default port number value is 4000. The port number value must be less than 65535.

SmbVersionRange={version_range}SmbVersionRange—Controls the SMB protocol version that is used in SMB printer communication. The client only uses the SMB version that is specified in version_range.

The format of version_range is lowest_version, highest_version. LM2 stands for LAN manager 2, SMB1 for SMB version 1, and SMB2 for SMB version 2. For example, SmbVersionRange=SMB2,SMB2 means only SMB version 2 is allowed; SmbVersionRange=,SMB2 means SMB version 2 and all the supported lower versions can be used. Default version range is set by SmbVersionRange=,SMB1. By default, SMB2 is not supported.


  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\