Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell PowerEdge R730 Owner's Manual

PDF

Installing the control panel

Prerequisites

  1. Follow the safety guidelines listed in safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the #2 Phillips screwdriver ready.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
    NOTE: Information tag lists system information such as Service Tag, NIC, and MAC address.
  2. To install the information tag, push the information tag into the control panel slot.
  3. Connect all the applicable cables to the control panel.
  4. Slide the control panel into the slot in the chassis and secure the module with the screw.
    Figure 1. Installing the control panel—3.5 inch hard drive system
    This figure shows installing the control panel—3.5 inch hard drive system.
    1. control panel
    2. control panel board
    3. control panel connector cable
    4. USB connector cable
    5. screw
    6. vFlash media connector cable
    Figure 2. Installing the control panel—2.5 inch hard drive system
    This figure shows installing the control panel—2.5 inch hard drive system.
    1. control panel
    2. control panel board
    3. control panel connector cable
    4. USB connector cable
    5. screw (2)
    6. vFlash media connector cable
    Figure 3. Installing the information tag
    This figure shows installing the information tag.
    1. information tag
    2. tab
    3. slot

Next steps

Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\