Alienware m18 R2 Owner's Manual

PDF

Installing the speakers

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image indicates the location of the speakers and provides a visual representation of the installation procedure.

Figure 1. Installing the speakers
Installing the speakers

Steps

  1. Using the alignment posts, place the left and right speakers into their slots on the palm-rest and keyboard assembly.
    NOTE:Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
  2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
  3. Connect the speaker cable to the audio board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\