Alienware m18 R2 Owner's Manual

PDF

Installing the USB Type-C board

CAUTION:The information in this installation section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the USB Type-C board and provide a visual representation of the installation procedure.

Figure 1. Installing the USB Type-C board
Installing the USB Type-C board

Steps

  1. Align the USB Type-C board with the screw holes on the system-board assembly.
  2. Align the USB Type-C shield on the left side with the screw holes on the system-board assembly.
  3. Replace the three screws (M2x4) that secure the USB Type-C board to the system-board assembly.
  4. Connect the USB Type-C board cable connector to the USB Type-C board and close the latch to secure the cable.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\