Alienware m18 R2 Owner's Manual

PDF

Removing the memory module

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

NOTE:This computer may have up to two memory modules installed.

The following image(s) indicate the location of the memory module and provides a visual representation of the removal procedure.

Figure 1. Removing the memory module
Removing the memory module

Steps

  1. Lift the Mylar to access the memory.
  2. Use your fingertips to carefully spread apart the securing-clips on each end of the memory-module slot until the memory module pops up.
  3. Slide and remove the memory module from the memory-module slot.
    CAUTION:To prevent damage to the memory module, hold the memory module by the edges. Do not touch the components or metallic contacts on the memory module as electrostatic discharge (ESD) can inflict severe damage on the components. To read more about ESD protection, see ESD protection.
    NOTE:Repeat the steps to remove any other memory module installed in your computer.
    NOTE:Note the slot and the orientation of the memory module in order to replace it in the correct slot.
    NOTE:If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from the slot.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\