Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Latitude 7390 Owner's Manual

Installing display assembly

  1. Place the base of the computer on a plane surface of a table and position it closer to the edge of the table.
  2. Install the display assembly to align it with the display hinge holders on the system.
  3. Hold the display assembly, tighten the M2 x 3.5 screws to secure the display hinges on the system display assembly with the system unit.
  4. Affix the tapes to secure the eDP cable (display cable).
    • NOTE: For touch-configuration system you see touch display cable, secure it with tapes along with the eDP cable.
  5. Connect the eDP cable to the connector on the system board.
    • NOTE: For touch-configuration system, connect the touch display cable to its connector on the system board.
  6. Install the eDP metal bracket on the eDP cable and tighten the M2 x 3 screws.
  7. Route the WLAN and WWAN cables through the routing channels.
  8. Install the:
    1. WLAN card

    2. WWAN card

    3. battery

    4. base cover

  9. Follow the procedure in After working inside your computer .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\