Dell ThinOS 10.x 2502, 2505, 2508, and 2511 Release Notes

PDF

Supported platforms

The Dell ThinOS 10.x firmware is supported on the following Dell and non-Dell platforms:

Table 1. Dell and non-Dell platformsThe Dell ThinOS 10.x firmware is supported on the following platforms:
Supported platforms Model
Thin Clients
  • Wyse 5070 Thin Client
  • Wyse 5070 Extended Thin Client
  • Wyse 5470
  • Wyse 5470 All-in-One
OptiPlex
  • OptiPlex 3000 Thin Client
  • OptiPlex 5400 All-in-One
  • OptiPlex All-In-One 7410
  • OptiPlex All-in-One 7420
  • OptiPlex Micro Plus 7010
Latitude devices
  • Latitude 3420
  • Latitude 3440
  • Latitude 5440
  • Latitude 5450
  • Latitude 5540
  • Latitude 5550
Dell Pro series
  • Dell Pro Rugged 13 RA13250
  • Dell Pro Rugged 14 RB14250
  • Dell Pro 16 Plus PB16250
  • Dell Pro 14 PC14250
  • Dell Pro 24 All-in-One
Non-Dell platform
NOTE:All hardware support for non-Dell devices must be secured from the device manufacturer.
 Amulet Hotkey (DX1500 series)
NOTE:To obtain the Dell recovery image, go to Support | Dell, and search for the latest ThinOS 10 recovery image. Use the same image for recovery/offline USB imaging.
NOTE:The minimum supported configuration for ThinOS 10.x is 32 GB storage and 8 GB RAM. ThinOS 10.x supported platforms do not support Intel i7 processors.
NOTE:Firmware upgrade from ThinOS 9 to ThinOS 10 is not supported on devices with 4 GB RAM.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\