OptiPlex 5090 Micro Form Factor Service Manual

PDF

Installing optional I/O modules (Type C/HDMI/VGA/DP/Serial)

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the system board and provide a visual representation of the installation procedure.

Installing optional I/O modules

Installing optional I/O modules

Installing optional I/O modules

Installing optional I/O modules

Steps

  1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket. Push the bracket to release the bracket, and then lift the bracket out from the system.
  2. Insert the optional I/O module (Type-C/HDMI/VGA/DP/Serial) into its slot from the inside of your computer.
  3. Connect the I/O cable to the connector on the system board.
  4. Replace the two (M3X3) screws to secure the optional I/O module to the system.

Next steps

  1. Install the side cover.
  2. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\