OptiPlex 5090 Micro Form Factor Service Manual

PDF

Installing the 2.5 in. hard-drive assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the hard-drive assembly and provides a visual representation of the installation procedure.

Image: Installing the hard drive assembly

Steps

  1. Insert the hard-drive assembly into the slot on the system.
  2. Slide the hard-drive assembly towards the connector in the system board until the release tabs clicks into place.

Next steps

  1. Install the side cover.
  2. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\