OptiPlex 5090 Micro Form Factor Service Manual

PDF

Installing the hard-drive bracket

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the hard-drive bracket and provides a visual representation of the installation procedure.

Image: Installing the hard drive bracket

Steps

  1. Place the hard-drive into the bracket.
  2. Align and insert the pins on the drive bracket with the slots on the drive.
    NOTE:Note the orientation of the hard-drive so that you can replace it correctly.

Next steps

  1. Install the side cover.
  2. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\