OptiPlex 5090 Micro Form Factor Service Manual

PDF

Installing the side cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the side cover and provides a visual representation of the installation procedure.

Image: Installing the side cover

Image: Installing the thumbscrew

Steps

  1. Align the side cover with the grooves on the chassis.
  2. Slide the side cover towards the back of the system to install it.
  3. Tighten the thumbscrew (6x32) to secure the side cover to the system.

Next steps

  1. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\